Pressure and Vacuum Relief Valve
made of plastic

Función y Descripción

The PROTEGO® valve VD/KSM -PA is a state-of-the-art pressure and vacuum relief valve with excellent flow performance made of highgrade synthetic material. Typically the valve is installed in the in- and out-breathing lines of tanks, vessels and process apparatus to protect against unallowable high or low pressure. The valve prevents emission losses almost up to the set pressure. The valve is a perfect solution for corrosive, polymerizing or sticky media.

The device will start to open as soon as the set pressure is reached and only requires 10% overpressure to full lift. Continuous investments into research and development have allowed PROTEGO® to develop a low pressure valve which has the same opening characteristic as a high pressure safety relief valve. This “full lift type” technology allows the valve to be set just 10% below the maximum allowable working pressure and vacuum (MAWP and MAWV) of the tank and still safely vent the required mass flow. The opening characteristic for pressure and vacuum side is the same.

Due to our highly developed manufacturing technology the tank pressure is maintained up to set pressure with a tightness that is far superior to the conventional standard. This feature is achieved by special valve seats made of high quality synthetic material or PTFE. After the excess pressure is discharged or vacuum is compensated, the valve reseats and provides a tight seal.

The optimized fluid dynamic design of the valve body and valve pallet is a result of many years of research work, which allow a stable operation of the valve pallet and optimized performance resulting in reduction of product losses.

Características especiales y ventajas

  • “full lift type” technology valve utilizes only 10% overpressure to reach full lift
  • extreme tightness and hence least possible product losses and reduced environmental pollution
  • the set pressure is close to the opening pressure which results in best possible pressure management of the system
  • the valve pallet is guided within the housing to protect against harsh weather conditions
  • corrosion resistant valve
  • perfect solution for corrosive, polymerizing and sticky media
  • weight reduction in comparison to steel/stainless steel
  • vacuum side self draining and pressure side condensate drain
  • smooth surface
  • different plastics can be combined
  • maintenance friendly design

Modelo y especificación

The valve pallets are weight-loaded, and the highest pressure levels are only attained with metal discs.

Pressure/vacuum valve in basic design


Pressure/vacuum valve in basic design


Additional special devices available upon request.



+6.0 mbar +100 mbar (DN 50/2”)
+2.4 inch W.C. +40 inch W.C.
+4.0 mbar +100 mbar (DN 80/3”)
+1.6 inch W.C. +40 inch W.C.
+4.5 mbar +100 mbar (DN 100/4” - DN 200/8”)
+1.8 inch W.C. +40 inch W.C.


-6.0 mbar -100 mbar (DN 50/2”)
-2.4 inch W.C. -40 inch W.C.
-4.0 mbar -100 mbar (DN 80/3”)
-1.6 inch W.C. -40 inch W.C.
-4.5 mbar -100 mbar (DN 100/4” - DN 200/8”)
-1.8 inch W.C. -40 inch W.C.
Higher and lower settings upon request

Diagrama de flujo volumétrico

Los diagramas de flujo volumétrico han sido determinados con un banco de pruebas de caudal calibrado y certifi - cado por TÜV. El flujo volumétrico V. en [m³/h] y el CFH se refi eren a las condiciones estándar de referencia de aire según ISO 6358 (20°C, 1bar). La conversión a otras densidades y temperaturas están referidas en el Vol. 1: “Fundamentos Técnicos”.