EH/0

EH/0

Vent Cap, End-of-Line

Función y Descripción

The PROTEGO® E/H0 vent cap allows vessels which are not pressurized to vent. This device prevents rain and dirt from entering the vent line. The EH/0 vent cap is not flame transmission proof. It is often used in combination with detonation flame arresters, when those are used in vent lines, installed at a Position which creates a long run up distance from the end of the vent
line to prevent endurance burning. The PROTEGO® EH/0 vent cap will then be installed at the end of that ventline to prevent particles or rain from entering the line. The vent cap PROTEGO® EH/0 main components are a housing (1), a weather hood (2) and a protection screen (3). The device is equipped with a fixed weather hood out of metal. The protection screen prevents particles or rain from entering the line.

Características especiales y ventajas

  • vent cap provides protection against environmental impact (harsh weather conditions, bird nests, etc.)
  • cost effective device
  • almost maintenance free
  • certified flow performance curves

Dimensiones

To select the nominal size (DN), please use the flow capacity charts on the following pages

DN20 / ¾" 25 / 1" 32 / 1¼" 40 / 1½"50 / 2" 65 / 2½" 80 / 3"
a163 / 6.42163 / 6.42163 / 6.42183 / 7.20183 / 7.20218 / 8.58218 / 8.58
b175 / 6.89175 / 6.89175 / 6.89190 / 7.48190 / 7.48200 / 7.87200 / 7.87
DN20 / ¾" 25 / 1" 32 / 1¼" 40 / 1½"50 / 2" 65 / 2½" 80 / 3"
a163 / 6.42163 / 6.42163 / 6.42183 / 7.20183 / 7.20218 / 8.58218 / 8.58
b175 / 6.89175 / 6.89175 / 6.89190 / 7.48190 / 7.48200 / 7.87200 / 7.87

Dimensiones en mm / pulgadas

EH/0

Selección de materiales

Design AB
HousingSteelStainless Steel
Weather hoodSteelStainless Steel
Design AB
HousingSteelStainless Steel
Weather hoodSteelStainless Steel

Special materials upon request

EH/0

Tipo de bridas de conexión

EN 1092-1; Form B1
ASME B16.5; 150 lbs RFSF
EN 1092-1; Form B1
ASME B16.5; 150 lbs RFSF

other types upon request

Modelo y especificación

Following designs are available:
Vent cap, basic design

EH/0

Vent cap, basic design

EH/0

Special designs available on request
EH/0

Diagrama de flujo volumétrico

Los diagramas de flujo volumétrico han sido determinados con un banco de pruebas de caudal calibrado y certifi - cado por TÜV. El flujo volumétrico V. en [m³/h] y el CFH se refi eren a las condiciones estándar de referencia de aire según ISO 6358 (20°C, 1bar). La conversión a otras densidades y temperaturas están referidas en el Vol. 1: “Fundamentos Técnicos”.

EH/0
EH/0